RSP Burner

Industrial Burners

The RSP series of gas burners are pre-packaged, fan assisted units designed to suit virtually all types of gas fired applications where recirculated air is utilised. The RSP can be fitted into process air ducts having air velocities of 5 to 30m/sec.

The burners can be installed in a process plant recirculation system where it is not possible to construct a combustion chamber and install a conventional type of burner assembly.

The units consist of an 'in-line PH' type combustion head mounted on a side plate so as to fire parallel to the side plate in direction of air flow. The burners are avilable in 'straight', 'T' and 'X' sections which enable the burner to be constructed to suit the appliance layout.

All air required for combustion is supplied by a combustion air fan mounted on the outside of the side plate; air is passed to the burner head via an integral air duct. Process air temperatures up to 300°C can be accepted upstream of the burner. Downstream temperatures should be limited to 600°C.

The burner systems produce a wide flame spread and a short flame; this feature means the burner is ideal for applications where chamber length is restricted.

The SP burner is simple and safe to operate. All burners are prefired and fully tested before leaving our works.

General information sheet

Typical Applications

-Industrial Ovens

-Industrial Dryers

-Ceramic Dryers

Duties

The RSP burner is available in sizes starting from 150Kw to more than 20MW and is available in high-low and modulating gas versions.

Fuels

Suitable for operation on Natural gas, LPG and most low calorific value gases

Gas Supply Pressure

Typically 20mbar. Higher inlet gas pressure can be accommodated

Typical Flame Length

At maximum duty = 600mm

Turndown

 

Up to 40:1

© 2019 Comtherm Ltd

  • Facebook Social Icon

01905 775783